![]() ![]() Wire Trak can be cut using hacksaw with fine-tooth blade. ![]() ![]() The basic installation requires no tools. Push the side of raceway to release the lock and open. The principle of cable management is to place cables in such a position that they go through as many cycles as the robot without breaking. Once in correct position, slowly remove balance of adhesive liner from under the Wire Trak. (Remember to apply the WireTrak to clean, dry surfaces.)įold back approximately 1 inch of adhesive liner on an angle exposing liner from under Wire Trak on both ends and place in position to check alignment. Measure how much cable you want to cover. Lay out and check over installation plan before sticking in place. Just bind the cords together and wrap the. Adhesive backing for fast-easy installation Cable Management Sleeve 14 AT AMAZON Best for: Computer cords We have a feeling the wires behind your work computer could use something like this.Folds into a rigid PVC channel for wire or cable installations.Knowing that up to 100 feet of raceway packed in a box the size of a pizza box is always on hand is comforting also. Then remove the tape backing and apply to clean dry surface. Just rollout the length you need, cut with ordinary scissors, and fold into a rigid channel shape. Low profile and paintable surface allow this surface mount raceway to be used on installations where minimum presence is required. Wire Track On A Roll 1/2" H x 1" W - 50 FT, White, Raceway, Cable Management ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |